DH5α receptor cells produced by our company are prepared by special process using Escherichia coli DH5α strain, which can be used for chemical transformation of DNA. Using pUC19 plasmid detection, the conversion efficiency can reach 108, and the conversion efficiency does not change after 3-5 months of storage at -70℃.

Genotype: supE44△lacU169 (φ80 lacZ△M15) hsdR17 recA1 end A1 gyrA96 thi-1 relA1

Features: A recombinant defective inhibited strain for laying and cultivating plasmid plates and clay plates. The product of φ80 lacZ△M15 gene can complement the amino end of β-galactosidase encoded by pUC vector, and can be used for blue-white spot screening.

Operation method: (The following operations are carried out according to the standard of aseptic conditions)

1. Put the receptive cells on ice to melt. The following experiment takes the 100μL receptive cells as an example.

2. Add the target DNA to be transformed into the receptive cell suspension, and pay attention to the volume of the target DNA not exceeding one-tenth of the volume of the receptive cell suspension, gently rotate the centrifuge tube to mix the contents, and place it in an ice bath for 30min.

3. Place the centrifuge tube in a 42-℃ water bath for 60-90s, and then quickly transfer it to the ice bath for 2-3min, taking care not to shake the centrifuge tube.

4. 500μL sterile and non-resistant SOC or LB medium was added into the centrifuge tube and cultured for 1h by oscillating at 180rpm at 37℃. The aim is to make the relative resistance marker genes expressed on the plasmid, so as to revive the bacteria.

5. Appropriate amount of transformed receptive cells were coated with SOC or LB plates containing corresponding antibiotics and cultured invert at 37℃ for 12-16h. The amount of coating can be adjusted according to the specific experiment, such as the total amount of converted DNA is more, the conversion product coating plate of about 100μL is preferable; Conversely, if the total amount of converted DNA is small, 200-300μL of conversion product coating is preferable. Excessive bacterial fluid can inhibit bacterial growth. If few clones are expected, part of the culture solution can be removed by centrifugation, and the bacteria can be suspended and coated on a plate. The remaining bacterial solution can be stored at 4℃. If the number of transformed colonies is too low the next day, the remaining bacterial solution can be coated with a new plate.

Note:

1, The receptive cells should be stored at -70℃, can not be frozen and thawed repeatedly, otherwise its conversion efficiency will be reduced.

2, The experiment should be strictly aseptic operation, to prevent the contamination of other DNA or miscellaneous bacteria, to avoid the impact on future screening and identification.

3. During conversion, the conversion efficiency is proportional to the concentration of foreign DNA within a certain range, but when the amount of foreign DNA added is too large or the volume is too large, the conversion efficiency will be reduced. At the time of transformation, the DNA volume is less than one-tenth of the volume of the receptive cell.

4. Calculation of conversion rate: conversion rate = total number of colonies generated/total amount of pavement DNA.

5, In order to prevent the conversion experiment from being unsuccessful, some of the connected products can be retained to re-transform and minimize the loss.

Note：Product information may be optimized and upgraded. Please refer to the actual label information for accuracy.